sdipesh182 sdipesh182

23-05-2023
Engineering

contestada

calculate the time required to turn a stepped shaft to the dimensions shown in below figure. From MS stock of 4cm diameter. Neglect Facing and set up Time. The depth of cut should not exceed 0.25cm. Assume the cutting speed to be 20m/min and Feed to be 0.3 mm/revolution For each cut.

calculate the time required to turn a stepped shaft to the dimensions shown in below figure From MS stock of 4cm diameter Neglect Facing and set up Time The dep class=

Respuesta :

Otras preguntas

match the following terms 1. Eisenhower's opponent during the election of 1952 a. Dwight D. Eisenhower 2. West Point graduate, President of the United States

In dogs, there is a hereditary deafness caused by an autosomal recessive Gene,"d". A kennel owner has a male dog that she wants to use for breeding purposes if

Happy Chanukah in Spanish

Write an equation that models the sequence 200 , 500 , 1250

what was the purpose of creating zebroids

Graph the function. h(x)=\dfrac{1}{4}(x -1)(x +7)h(x)= 4 1 (x−1)(x+7)

ABCD is a rectangle. The measure of angle BCE is 4x-23 and the angle measure of angle DCE is 5+5x. Find the measure of angle BEC

two equations for the constant of proportionality equal to 1/2

1: what style of teaching did Socrates practice? what were some important features of this type of teaching? 2: what type of society did plato envision?3:what w

que es pensamiento argumentativo?